Question NVME USB drives Realtek RTL9210/RTL9220 Firmware Version 1.xx

Yes. I tried both the USB 3.2 Gen2 (CPU SoC) and USB 2.0 (additional HUB connected to chipset provided USB 3.x) ports.
The board clearly goes into a "boot loop" (or boots and resets). I think this is because I have an incorrect config now.
This is the board I tried to flash. I guess I should have been more careful and realize that not all boards might work with all .bin and .cfg file combinations:
photos.app.goo.gl/kin7ttCgepyoz17PA
I contacted the Aliexpress seller but they can't provide any kind of firmware (including the original these boards are shipped with).

TheGiolly 씀:

Ok, It was a problem with the .cfg file.
To make it work:
- Dump -> Show Device Info -> Save
- Delete first 3 lines and all the lines after the empty line towards the end
- Substitute all the ":" characters with "=" characters
- Save as .cfg and use it in UTHSB_MPtool_Lite
Hope this is useful to someone else!

 

this tips solved my problem, to update fw thanks a lot, but the freezing problem after idle time continues

Looks like my only option is to find oneone with an identical board and give me a config dump.
Or me buying yet another identical and do it for myself. -> What are my chances of recovering that way?

Hi, I bricked my Orico SSD NVMe enclosure with the RTL9210B.
I read that you can reset the flash memory connecting the 1 & 8 pin, but I do not which its the chip.
Someone can help with the pictures please?
Thx!

IT's usually the one with the hole and the one on the other side. Although, if you already over-written the config, I don't know how to recover from that.
Could you please sump your config onnce you get it into recovery mode?