Marvell/Aquantia AQC113CS (10Gbps) Firmware Version 1.5.45

Be careful, as some external PCI-E cards (probably not Rev 3) are not compatible, so read the messages carefully.

Here is the command for firmware recovery:
flashUpdate2.exe --reflash xxxxxxxx.clx

AQC113 Firmware Flashing and Recovery Notes · GitHub

Otherwise, I haven't had any problems with my Z890 ProArt so far.

Definitely do a clean install of your old firmware.

 

admin escribió:

Be careful, as some external PCI-E cards (probably not Rev 3) are not compatible, so read the messages carefully.

Here is the command for firmware recovery:
flashUpdate2.exe --reflash xxxxxxxx.clx

AQC113 Firmware Flashing and Recovery Notes · GitHub

Otherwise, I haven't had any problems with my Z890 ProArt so far.

Definitely do a clean install of your old firmware.



 

Connected to device 'NDISIO:14C0-00E:00.0'
Error: RBL failed to start after issuing reset
Failed load UpdateAgent

Unable to flash

Also this error
flashupdate2 -i
flashUpdate2 x86_64-w64-mingw32-4.10-126-g5407c89

Connected to device 'NDISIO:14C0-00E:00.0'
FourPartIDs:0x0000:0x0000:0x0000:0x0000

The chipset is recognized; if so, try with a different firmware or the last one that worked.

Note: Use the latest drivers, version 3.1.11.0.

Same error with other firmware. Tried it by booting into Hiren Boot PE. Windows can recognise the card and HWID shows the correct 4 parts. But updater doesn’t see. Only sees 0000 0000 0000 0000. It cannot reset the card as well. 

In CMD, launch the command flashUpdate2.exe -h; you will have options to force the update.